New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Questions about Edis.at [SOLVED]
Anybody has experience of vserver from Edis.at? I bought one yesterday and use NodeQuery.com as monitoring. It's very strange that I use very little on the bandwidth but it shows:
CPU Model Intel(R) Xeon(R) CPU E5649 @ ...
CPU Speed 24x 2533 MHz
Network Activity ↑↓ 664.61 KB/s
Total Outgoing ↑ 28.81 GB
Total Incoming ↓ 17.43 GB
How does "vserver" work, is it OpenVZ ?
Thanked by 1lelewku
Comments
@William
http://en.wikipedia.org/wiki/Linux-VServer
Have you contacted them? How does your monitoring script calculate the value?
as i rember - yes.
It's a mixture of OpenVZ, KVM & a touch of magical faerie dust.
It used to be a custom solution based on linux vserver. Dunno if that did change though.
It's pretty close to openvz...
^ This
What script are you using to monitor bandwidth though?
It's been a rough time using VServer, many downtime, so that I have to do an upgrade toward the KVM.
But luckily my discounts goes on applicable on the upgraded plan, though it was quite a bit out of my budget still.
Bandwidth stats are server-wide in vserver, run ifconfig and you'll probably see several terabyte of traffic
Your calculation is not only your traffic, its the nodes. This is normal on VServer.
No, VServer is not OpenVZ but similar to it.
@William Thank you. That's very helpful.