New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Comments
This should be straight forward:
https://community.hetzner.com/tutorials/install-and-configure-proxmox_ve
What is straight forward to you, is not straight forward to me...
What is your issue?
A lot of us use proxmox here.
Is Proxmox already installed?
I believe you can just add this to your network configuration for NAT:
Replace eth0 with your primary interface name
Once added, select vmbr0 for VPS NIC and then use any IP from 10.10.10.0/24 (i.e. 10.10.10.2, 10.10.10.3, 10.10.10.4 for the VMs). Gateway will be 10.10.10.1 and Netmask will be 255.255.255.0 for each VM.
This is not complicated, I have dealt with over a dozen Hetzner Proxmox installations. The official documentation explains NAT IPv4, and with some additional configurations, you can also configure IPv6 for each VM.
If you are willing to describe more, you will receive more help.
Looks easy enough. How much are you paying?
Thank you very much mate, this worked flawlessly
If you need IPv6 too, I can help for free.
I understand you perfectly. The configurations that worked for me on the OVH/KIMSUFI dedicated servers did not work for me on Hetzner.
https://virt.spiritlhl.net/en/
Use this one click script, be sure to reinstall the system and then use the script to install proxmox.