New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Wireguard client on Ubuntu server / NAT client into Tunnel without running server traffic into it
I am trying to run a wireguard client on my ubuntu server. I want to NAT some client traffic into the wireguard tunnel without the tunnel taking over all server traffic. Essentially, I want this wireguard tunnel to function like a GRE tunnel where I can use iptables to control what goes into wireguard. I can't seem to find a way of doing that. Any configuration recommendations?
Comments
add
AllowedIPsto your conf fileWhen I AllowedIPs = 0.0.0.0/0, it will take over the entire outgoing traffic of the server. I want to route by source IP. Not route by destination as in the AllowedIPs in wireguard configuration
Try Table = off or adjust AllowedIPs
How do I do table = off? I want AllowedIPs to route 0.0.0.0/0 so that when I do SNAT, the destination can be any
You add that to your wg-quick config file.
Thanks. It works!!!