New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Add ipv6 to vultr
Hello
I have tried add ipv6 to vultr vps but some issue
This is my config
`Populate the /etc/sysconfig/network-scripts/ifcfg-eth0 file with the following text.
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=45.32.61.111
NETMASK=255.255.252.0
GATEWAY=45.32.60.1
DNS1=108.61.10.10
IPV6INIT=yes
IPV6ADDR="2001:19f0:7001:2210:4400:01ff:fecd:f7d8/64"
IPV6_AUTOCONF="yes"
DNS2=2001:19f0:300:1704::6
Populate the /etc/sysconfig/network-scripts/route-eth0 file with the following text.
169.254.0.0/16 dev eth0
Restart networking or reboot.
service network restart`
I have hard reboot my vps
But my vps got only main ip 2001:19f0:7001:2210:4400:01ff:fecd:f7d8
Can you help me thank
Comments
Isn't it automatic from the client console?
Try adding
IPV6ADDR_SECONDARIES="2001:19f0:7001:2210:4400:01ff:fecd:dead/64 [more ipv6/64 separated by spaces]"Hello
@FrankZ Can I Add all ipv6 subnet via this or need one by one ?
Don't try to trigger me.
I have tried add subnet to IPV6ADDR_SECONDARIES="2001:19f0:7001:2210::/64" but don't work , Can you check help me @FrankZ
You can not add IPv6 addresses as a block you will need to set the address that you wish to use so for example:
IPV6ADDR_SECONDARIES="2001:19f0:7001:2210::a/64 001:19f0:7001:2210::b/64 001:19f0:7001:2210::c/64"