New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
OpenVZ IPv6 subnets ?
Hello,
I was trying to figure out how SolusVM manages to provide /80 subnets and the like for OpenVZ while routing it all via the same default gateway. I tried this on plain/vanilla OpenVZ and it doesn't seem to work out if I add in a /80 address, it tries to route it out via the /80's gateway rather than the gateway set on the host-node. Any idea how to route it all out via 1 default gateway?
This discussion has been closed.
Comments
Are you specifying the mask when adding the gateway?
You mean on the host-node config ? Hmm probably not, was a test node I setup last night. I'll check into this.
Added the netmask to the config, Adding 2607:f0d0:1002:0011:0001::2 to a VPS doesnt work, MTR to ipv6.google.com from the VPS goes till the host-node and drops, while if I add a address like 2607:5600:00e8:0000:0000:0000:0000:0003 to the VPS it works fine.Typo error on my part 2607:f0d0: != 2607:5600:, fixed
Closed at OP request.
And
haha