New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Debian Jessie
Hi
I today installed debian Jessie on my homeserver and I ran into several problems;
- Segmentation Fault with USBHID-UPS (NUT)
- Reboot over SSH ends in a "Broken Pipe"
- SNMP Interface Description is nos "Intel Gigabit ...." instead of "eth0", all monitoring scripts refuse to work
What are your experiences about jessie?
Regards
Patrick
Comments
This is not a bug.
I think you need to change if_discription or may be OIDs was changed.
Install fresh version of NUT or use debian stable.
Then please tell me how to correct reboot the system ;-)
No, not OIDs were changed, but the content. In the past, it was the interface name, now the interface description
Segmentation fault was in LIBC ;-)
Stable works, but in 19 days Jessie will be released officially. So these bugs should be fixed then.
If the "Broken pipe" message bothers you that much (all it means is that your connection dropped, you know, because the server rebooted), you can run
reboot && exit
and you'll disconnect before the reboot is processed.But with reboot, the server reboots immediately, without shutting down all services, as it was in wheezy, right?