New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Regarding bridge setup with ifcfg-p2p1 ethernet 10GBPS port
Hi,
We need to configure bridge setup with ifcfg-p2p1 ethernet 10GBPS port.
ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:109 errors:0 dropped:0 overruns:0 frame:0
TX packets:109 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:38804 (37.8 KiB) TX bytes:38804 (37.8 KiB)
p2p1 Link encap:Ethernet HWaddr
inet addr:Main IP Bcast:IP address Mask:Gateway
inet6 addr: fe80::92e2:baff:fecb:aef8/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4462808 errors:0 dropped:0 overruns:0 frame:0
TX packets:2021159 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:319424221 (304.6 MiB) TX bytes:110687577 (105.5 MiB)
How can we configure bridge with it? Please let us know.
Thank you for your help!
