New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
virtualizor kvm vps.
How do I change my speed to 1000MB/s to use the same port speed from the host itself.
root@irc:~# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised pause frame use: Symmetric
Advertised auto-negotiation: Yes
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Link partner advertised pause frame use: Symmetric
Link partner advertised auto-negotiation: No
Speed: 100Mb/s
Duplex: Full
Comments
right now by default if you create a KVM vps on virtualizor. It will only have 100mb/s
Please help
Change Virtual Network Interface Type Realtek 8139 to Intel E1000.
virtualizor use KB/s instead of Kb/s
thank you.
the configuration is limited by admin. so you might be able to change the numbers but find it makes no difference. if you want 1000Mb/s you will probably need to ask the provider to lift the min setting
This one actually working. thank you
the default for virtualizor KVM is the Realtek 8139, which is a 10/100